HPE ProLiant DX380 Gen10 - Installing a Front 6 SFF SAS;SATA + 2 Nvme Premium Drive Cage

9. Install the associated NVMe riser.
10.
Connect the power cable to the drive backplane power connector.
11.
Connect the data cables from the drive backplane to the NVMe riser.
12.
Install drives or drive blanks.
The installation is complete.
Installing a front 6SFF SAS/SATA + 2NVMe Premium drive cage
The drive cage can be installed in any box. This procedure covers installing the drive cage in box 1.
Prerequisites
A storage controller and high-performance fans are required when installing this drive cage.
Procedure
1.
Observe the following alerts.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause ESD.
2. Power down the server.
3. Do one of the following:
• Extend the server from the rack.
•
Remove the server from the rack.
4. Remove the access panel.
5.
Remove the air bale.
Hardware options installation
100