HPE ProLiant DX380 Gen10 - Battery Replacement Procedure

Battery replacement
If the server no longer automatically displays the correct date and time, you may need to replace the battery that provides
power to the real-time clock.
WARNING: The computer contains an internal lithium manganese dioxide, a vanadium pentoxide, or an alkaline
battery pack. A risk of fire and burns exists if the battery pack is not properly handled. To reduce the risk of
personal injury:
• Do not attempt to recharge the battery.
• Do not expose the battery to temperatures higher than 60°C (140°F).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
• Replace only with the spare designated for this product.
To remove the component:
1. Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
4.
Remove the access panel.
5.
If installed, remove the secondary PCIe riser cage.
6.
Locate the battery.
7.
Remove the battery.
Battery replacement
191