HPE ProLiant DX380 Gen10 - Cable Routing: Smart Array P824 I-P Controller

SAS expander to a p-type controller
Cable routing: Smart Array P824i-P Controller
Observe the following:
• Do not store excess cabling in the rear of the server. This blocks airflow and increases heat inside the server.
• Extra cable slack should be stored towards the front of the server, near the drive backplane.
Backup power cable
A smart storage battery is required with this controller. Your riser might look dierent from the one shown. To locate a
backup power connector, see "Riser board components".
Cabling
170