15. Install the system air baffle .
16. Install the access panel .
17. Do one of the following:
Orient the server back to tower mode.
Install the server into the rack.
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server.
ResultsResults
The installation is complete.
HPE NS204i-u Boot Device HPE NS204i-u Boot Device optionoption
Note the following information about the HPE NS204i-u Boot Device option:
The HPE NS204i-u Gen11 NVMe Hot Plug Boot Optimized Storage Device (NS204i-u) is a PCIe5 custom form factor module that
includes two hot-pluggable 2280 M.2 NVMe SSDs.
This boot device enables the deployed OS to be mirrored through a dedicated hardware RAID 1.
The boot device auto-creates a RAID1 volume during boot. This means the boot device does not require further RAID configuration.
This boot device is compatible with the following native OS:
Windows
Linux
VMware
This boot device uses native inbox OS NVMe drivers.
SubtopicsSubtopics
Installing the HPE NS204i-u Boot DeviceInstalling the HPE NS204i-u Boot Device
Installing the Installing the HPE NS204i-u Boot DeviceHPE NS204i-u Boot Device
PrerequisitesPrerequisites
Before you perform this procedure, make sure about the following:
The redundant fan option kit is installed.
The server is updated with the latest operating system firmware and drivers .
Identify the HPE NS204i-u Boot Device components.
Before you perform this procedure, make sure that you have the following items available:
To Next Page
Loading...
