Item LED Status Definition
Flashing green The drive is rebuilding or performing a
RAID migration, strip size migration,
capacity expansion, or logical drive
extension, or is erasing.
Flashing amber/green The drive is a member of one or more
logical drives and predicts the drive
will fail.
Flashing amber The drive is not configured and
predicts the drive will fail.
Solid amber The drive has failed.
Off The drive is not configured by a RAID
controller.
IMPORTANT:
The Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode. It cannot be enabled in
Legacy BIOS Boot Mode. If the B140i controller is disabled, drives connected to the system board Mini-
SAS connectors operate in AHCI or Legacy mode. Under this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to enable or disable the
B140i controller (System Configuration
®
BIOS/Platform Configuration (RBSU)
®
System Options
®
SATA Controller Options
®
Embedded SATA Configuration).
GPU accelerator numbering
• Server left GPU accelerator numbering
GPU accelerator numbering 15
To Next Page
Loading...
