8. Disconnect the cables from the drive backplane:
a. Disconnect the Mini-SAS cables.
b. Disconnect the power cable.
9. Remove the drive cage assembly:
a. Loosen the captive screws.
b. Slide the drive cage assembly towards the front and lift it from the server.
Installing the drive cage assembly
Procedure
1. Install the drive cage assembly:
a. Lower the drive cage assembly into the server and slide it towards the rear to align the screw holes with
the captive screws.
b. Tighten the captive screws.
30 Installing the drive cage assembly
To Next Page
Loading...
