HPE ProLiant XL270d Gen9 - Removing the Air Baffle

Removing the air baffle
Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server .
4. Remove the server from the chassis.
5. Place the server on a sturdy, level surface.
6. Remove the access panel.
7. If a Smart Storage Battery is installed, disconnect the cable from the riser board.
8. If installed, disconnect the 4:1 riser signal cable:
a. Open the latches on the connectors.
b. Disconnect the cable from the connectors.
9. Remove the air baffle.
Removing the air baffle 27