HPE ProLiant XL270d Gen9 - Installing the 8:1 PCI Riser Modules

Installing the 8:1 PCI riser modules
About this task
To install the component:
Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server front panel.
4. Remove the server from the chassis .
5. Place the server on a sturdy, level surface.
6. Remove the access panel.
7. If installed, remove the Smart Storage Battery:
a. Disconnect the cable from the riser connector.
b. Pull back the release clip.
c. Lift the Smart Storage Battery from the holder.
8. Disconnect and remove the 4:1 riser signal cable.
56 Installing the 8:1 PCI riser modules