Procedure
1. Back up all server data.
2. Power down the server .
3. Disconnect all peripheral cables from the server front panel.
4. Remove the server from the chassis .
5. Place the server on a sturdy, level surface.
6. Remove the access panel.
7. If installed, remove the Smart Storage Battery:
a. Disconnect the cable from the riser connector.
b. Pull back the release clip.
c. Lift the Smart Storage Battery from the holder.
8. Remove the air baffle.
IMPORTANT:
Remove all GPUs, GPU blanks, and expansion boards before removing the PCI riser modules.
9. Remove the side panel.
10. Remove all GPUs:
a. Loosen the captive screw.
b. Using both hands, gently pull the tab and the rear support bracket to slide out the GPU to access the
power cable.
46 Hardware options installation
To Next Page
Loading...
