CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
7. Remove the GPU:
a. Loosen the captive screw.
b. Using both hands, gently pull the tab and the rear support bracket to slide out the GPU to access the
power cable.
c. Disconnect the power cable from the GPU, and then remove the GPU from the server.
8. Install the GPU blank:
a. Slide the GPU blank into the server.
b. Tighten the captive screw.
9. Install the side panel.
10. Install the server into the chassis.
11. Connect all peripheral cables to the server .
12. Power up the server .
Hardware options installation 81
To Next Page
Loading...
