8. Cable the drive backplane.
9. Install drives or drive blanks.
10. Install the access panel.
11. Slide the server into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server.
The installation is complete.
Installing a rear 2SFF SAS/SATA drive cage over the power
supplies
Prerequisites
Before installing this option, be sure that you have the following:
• T-10 Torx screwdriver
• The components included with the hardware option kit
• The front bays are fully populated with 12 LFF or 24 SFF drives
• High performance fans are installed in all fan bays
Procedure
1. Power down the server.
2. Remove all power:
152 Installing a rear 2SFF SAS/SATA drive cage over the power supplies
To Next Page
Loading...
