13. Connect each power cord to the power source.
14. Power up the server .
The installation is complete.
Installing a FlexibleLOM adapter
Prerequisites
• The components included with the hardware option kit
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Power down the server .
2. Do one of the following:
• Disconnect each power cord from the power source.
• Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the primary riser cage.
6. Remove the FlexibleLOM blank.
7. Install the FlexibleLOM adapter:
Installing a FlexibleLOM adapter 161
To Next Page
Loading...
