HPE StoreEasy 1X60 Storage

OK ( )
Connected: Indicates that the Network
Team Interface is connected.
Disabled Disconnected: Indicates that the Network
Team Interface is disconnected.
Creating a Network Team Interface
1. Click Settings > Networking > Network Team Interfaces from the left navigation menu in the
management console of the HPE StoreEasy.
2. Click add (+) icon on the top right-side of the Network Team Interfaces page.
3. Select the network team from the Network Team drop-down menu in the Create Network Team Interface
page.
You can also create a new network team by clicking Create new Network Team from the drop-down
menu. For creating a new network team, see Creating a new network team.
4. Click + or - icon in the VLAN ID section to specify the VLAN ID number.
5. Click edit ( ) icon in the IP Settings field to configure the IP and click on any of the following modes:
• Use DHCP
• Manually assign IP and DNS addresses
6. Click OK and click Create in the Create Network Team Interface page.
Editing a Network Team Interface
NOTE:
The primary Network Team Interface cannot be deleted, you can only configure the Network Team Interface
using the default VLAN ID.
1. Click Settings > Networking > Network Team Interfaces from the left navigation menu in the
management console of the HPE StoreEasy.
2. Click on the Network Team Interfaces that you choose to modify.
3. Click edit icon ( ) in the Network Team Interface page.
4. Click + or - icon in the VLAN ID section to set the VLAN ID.
5. Click edit icon (
) in the IP Settings section to configure the IP and click on any of the following modes:
• Use DHCP
• Manually assign IP and DNS addresses
6. Click OK.
7. Click Apply in the Edit Network Team Interface page to save the changes.
90 Creating a Network Team Interface