8. Locate slot 3, and then remove the expansion slot blank.
9. Install the 12G SAS expander card.
IMPORTANT:
The 12G SAS expander card requires a controller. The server supports embedded, type-a, and
type-p Smart Array controllers. If using a type-p Smart Array controller, then install the controller in
slot 1.
10. Using the labels on each cable, connect the cables to the SAS expander.
For drive numbering, see "Drive bay numbering: SAS expander on page 129".
11. Install the riser cage.
12. Connect cables from the 12G SAS expander to the controller.
13. Connect cables from the 12G SAS expander to the drive backplanes.
A standard configuration is shown. For additional cabling diagrams, see "#unique_226".
158 Hardware Components of HPE StoreEasy 1X60 Storage system
To Next Page
Loading...
