Figure 2: The lowest row of storage slots in the library are inaccessible to the robot if the library has a
Q6Q62A base module.
If an expansion module is installed below the Q6Q62A base module, the inaccessible storage slots will be in
the lowest expansion module and all of the storage slots in the base module will be accessible.
The numbers associated with the inaccessible storage slots are not used. For example, storage slots 1 and 6,
and mailslot MS1 are not visible in the RMI.
IMPORTANT: Do not install cartridges in any of the eight lowest storage slots in the library. If the library
detects cartridges in the eight lowest slots, the amber Attention LED will flash and the library will post a
Warning Event code 4126. The library will mark the cartridges as inaccessible and will not use them for
backup operations. Remove the cartridges from the eight lowest slots to clear the Warning Event and
turn off the flashing Attention LED.
Library user interfaces
• Remote management interface (RMI) — this interface lets you monitor and control the library from a web
page. You can access most library functions from the RMI.
• Operator control panel (OCP) — this interface lets you operate the library from the front panel.
The MSL3040 RMI
Before using the RMI, you must configure the library network settings and set the INITIAL RMI
administrator password with the OCP. You can configure the network settings and set the INITIAL RMI
administrator password with the Initial Configuration Wizard.
Use the INITIAL RMI administrator password to log in to the RMI the FIRST time as the administrator user.
The library will prompt you to set an actual RMI administrator password.
If one person physically installs the library and a second person configures the library using the RMI, share
the INITIAL RMI administrator password as appropriate. If the library is running firmware version 3210 or later,
10 Overview
To Next Page
Loading...
