HPE StoreEver MSL3040

5. From the front of the rack, starting at the rear adapter, mount the RHS rack shelf for each module into the
adapter blocks on the right side of the rack.
6. Ensure that each rack shelf tab is properly engaged with the front and rear adapters. Verify that the rack
shelf cannot move in the front-to-back axis of the rack.
Installing the base module in the rack
Prerequisites
#2 Phillips screwdriver
Procedure
1. If the top cover is not installed on the base module, set it aside on the work table.
2. From the front of the rack and while supporting the bottom of the module in the areas supported by the
rack shelves, set the back of the base module on the front of the shelves.
3. Push the base module into the rack until the front of the module contacts the front rack posts.
20 Installing the library