4. Tighten the blue captive thumbscrews with your fingers or a #2 Phillips screwdriver until it is finger tight.
Do not over tighten.
More information
Rear panel on page 6
Installing tape drives
When possible, install all tape drives during the initial library installation process before the library is powered
on. When installing additional tape drives after the library has been powered on, follow the instructions
included with the tape drive.
TIP: To assist in aligning the drive, only remove the drive bay covers for one drive at a time.
CAUTION: All drive bays without tape drives installed must have drive bay covers installed.
Prerequisites
• The module must have a power supply installed before powering on the library.
• #2 Phillips screwdriver
Procedure
1. Locate an appropriate vacant drive bay on the back of the library.
NOTE: A full-height drive can only be installed in the bottom two half-height drive bays. A full-height drive
cannot be seated in other locations and will not operate. If the drive will not seat completely, verify that it is
located in the correct drive bays.
2. Remove the face plate covering the drive bay by removing the screws holding it in place.
3. Holding the tape drive by the handle and supporting it from the bottom, slide the tape drive along the
alignment rails into the drive bay until it is flush with the back of the library.
Installing the library 27
To Next Page
Loading...
