HPE StoreEver MSL3040

release button is not pressed during those 10 seconds, the library locks all magazines and starts the
inventory process.
More information
MSL3040 storage slots on page 9
Verifying the installation
IMPORTANT:
• The library will only operate with both top and bottom library cover plates installed.
• Do not place anything on the top library cover plate, the weight may cause errors in the library
operation.
• Do not allow anything to contact the bottom library cover plate, contact may cause errors in the
library operation.
Procedure
1. Verify that the library and drives have the current firmware revision.
The library firmware revision is displayed in the top left corner of the OCP and RMI screen.
The drive firmware version is displayed on the RMI Status > Drive Status screen and the OCP Status >
Drive screen.
2. If necessary, update the library firmware from the OCP or RMI Maintenance > Firmware Upgrades >
System Firmware screen.
3. After configuring the library, you can save the configuration settings to a USB flash drive from the OCP
Configuration > Save/Restore > Save Configuration File or to a file on your computer from the RMI
Configuration > System > Save/Restore screen.
Having a backup of the library configuration is helpful when recovering from a configuration error or if the
library needs service.
4. Set the security user password from the Configuration > User Accounts screen.
Downloading product firmware
Procedure
1. Navigate to the HPE Support website: http://www.hpe.com/support/storage
IMPORTANT: Access to some updates might require product entitlement when accessed through
the Hewlett Packard Enterprise Support Center. You must have an HPE Passport set up with
relevant entitlements.
To view and update your entitlements, and to link your contracts and warranties with your profile,
navigate to: http://www.hpe.com/support/AccessToSupportMaterials
2. Browse or search for the necessary firmware.
3. Download the firmware.
To upgrade firmware from the OCP, copy the firmware image onto a FAT-32 formatted USB flash drive.
32 Installing the library