Aligning and connecting modules
Skip this step if the library does not have expansion modules.
Procedure
1. From the front of the library, loosen the screws on each of the modules two full turns.
2. From the back of the library, starting with the bottom pair of modules, align each module with the module
below. Repeat for each pair of adjacent modules.
a. Lock the alignment mechanism.
If the alignment mechanism has a lock, slide the lock to the left, move the alignment mechanism to the
locked position, and then release the spring-loaded lock.
If you encounter resistance, adjust the position of the upper module so the pin in the alignment
mechanism moves into the mating hole in the lower module.
3. Verify that the lowest module in the library has its alignment mechanism in the unlocked position.
4. From the front of the library, use a #2 Phillips screwdriver to tighten the captive fasteners on each side of
all of the modules until the fasteners are finger tight. Do not over tighten.
5. From the back of the library, connect each adjacent pair of modules with expansion interconnect cables, if
not already connected.
Installing the library 25
To Next Page
Loading...
