4. Use a #2 Phillips screwdriver to tighten the captive fasteners on each side of the base module until they
are finger tight. Do not over tighten.
5. Verify that the module is contained within the 3U rack volume.
Preparing the top and bottom modules
Skip this step if you are installing a base module only, without any expansion modules.
The base module has removable top and bottom cover plates.
Procedure
1. If an expansion module will be installed above the base module, move the top cover plate from the base
module to the top of the expansion module that will be installed at the top of the library.
2. If an expansion module will be installed below the base module, move the bottom cover plate from the
base module to the bottom of the expansion module that will be installed at the bottom of the library.
Moving the top cover plate
Procedure
1. Remove the top cover plate from the current module.
Installing the library 21
To Next Page
Loading...
