Procedure
1. Verify that the device bay is configured for a half-height compute module. For more information, see the
setup and installation guide for the frame on the Hewlett Packard Enterprise website.
2. Remove the compute module end cap.
3. Prepare the compute module for installation by opening the compute module handle
4. Install the compute module. Press the compute module handle near the release button to completely close
the handle.
5. To determine the compute module status, review the compute module front panel LEDs. For more
information on the compute module LEDs, see "Component identification."
To remove the component, reverse the installation procedure.
CAUTION: Before removing the compute module, verify that the compute module is in standby mode by
observing that the system power LED is amber. Also, verify that the UID LED is not flashing blue.
36 Removal and replacement procedures
To Next Page
Loading...
