To replace the component, reverse the removal procedure.
Removing and replacing DIMM baffles
Procedure
1. Power down the compute module .
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
4. Remove the access panel.
5. Remove one or more DIMM baffles.
6. If an energy pack is installed, remove it from the DIMM baffle.
To replace the component, reverse the removal procedure.
IMPORTANT: Be sure to install the energy pack in the same baffle from which it was removed when
replacing it.
Removal and replacement procedures 41
To Next Page
Loading...
