HPE Synergy 660 Gen10

To replace the component, reverse the removal procedure.
More information
Powering down the compute module on page 34
Removing and replacing a compute module end cap
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
4. Remove the compute module end cap.
To replace the component, reverse the removal procedure.
More information
Powering down the compute module on page 34
Removing and replacing a mezzanine option card
Procedure
1. Power down the compute module .
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
4. Remove the access panel.
5. Remove the mezzanine option card.
Removal and replacement procedures 39