To replace the component, reverse the removal procedure.
Removing and replacing the system board
Prerequisites
If HPE Persistent Memory modules are installed in the compute module and are encrypted with local key
management, do one of the following:
• Manually retrieve the HPE Persistent Memory module passwords from the compute module (user-
generated passwords only)
• Export a password file to a USB key.
Hewlett Packard Enterprise recommends exporting the password file to a USB key.
For more information, see the HPE Persistent Memory User Guide on the Hewlett Packard Enterprise website
(http://www.hpe.com/info/persistentmemory-docs).
• Access to HPE OneView
• Active internet connection
• T-30 Torx screwdriver
Procedure
1. Power down the compute module .
2. Unassign the server profile if it was assigned previously.
3. Remove the compute module from the frame.
4. Place the compute module on a flat, level work surface.
5. Remove the access panel.
6. Remove all drives.
7. Remove all drive blanks.
Removal and replacement procedures 57
To Next Page
Loading...
