Item Description
5 iLO Service Port (169.254.1.2) (located behind the Serial label pull tab)
6 External USB (located behind the Serial label pull tab)
7 Compute module handle release latch
8 Compute module handle
1
If uFF drives (the SFF Flash Storage Adapter) are installed in the drive bays, the drive bay numbering is different. For
more information, see Drive numbering.
Serial label pull tab information
The serial label pull tab is located on the front panel of the compute module. To locate the serial label pull tab,
see Front panel components. The serial label pull tab provides the following information:
• Product serial number
• HPE iLO information
• QR code that points to mobile-friendly documentation
Drive numbering
Depending on the configuration, the drive bay numbering on this compute module will vary. Supported
configurations on this compute module are shown in the following table.
Compute module model Configuration Drive support
SAS model Standard backplane with
embedded controller or supported
controller option
Four SFF hot-plug SAS drive bays
with support for up to 4 SFF HDDs
or SSDs
SATA model Chipset SATA with embedded
controller or supported controller
option
Four SFF hot-plug SATA drive
bays with support for the following:
• Up to 4 SFF SATA HDDs or
SSDs
• Up to 8 uFF SATA HDDs (with
the SFF flash adapter for each
2 uFF drives)
72 Component identification
To Next Page
Loading...
