Removing and replacing a drive
Procedure
1. Determine the status of the drive from the drive LED definitions.
2. Back up all data on the drive.
3. Remove the drive.
To replace the drive, slide the drive into the bay until it is fully seated, and then close the latch handle to lock
the drive in the bay.
Removing and replacing an SFF flash adapter
CAUTION: Removing the SFF Flash Adapter also removes two uFF drives and might cause one or
more logical drives to fail.
Procedure
1. Power down the compute module.
2. Slide the adapter ejection handle release latch up.
The handle will eject from the adapter.
3. Pull the adapter handle to remove the SFF flash adapter.
38 Removal and replacement procedures
To Next Page
Loading...
