Removing and replacing an access panel
Procedure
1. Power down the compute module .
2. Remove the compute module.
3. Press the access panel release button.
4. Slide the access panel towards the rear of the compute module, and then lift to remove the panel.
To replace the component, reverse the removal procedure.
Removing and replacing a drive blank
Procedure
1. Press the drive release button.
2. Remove the drive.
CAUTION: To prevent improper cooling and thermal damage, do not operate the compute module
unless all bays are populated with either a component or a blank.
To replace the component, reverse the removal procedure.
Removal and replacement procedures 37
To Next Page
Loading...
