4. In the Server hardware box, select unassigned.
5. Click OK.
Reassigning a server profile using HPE OneView
Procedure
1. From the HPE OneView main menu, select Server Profiles.
2. In the master profile, select the profile that was previously unassigned.
3. Select Actions > Edit.
4. In the Server hardware box, select the appropriate server.
5. Click OK.
Migrating a processor heatsink assembly to a replacement system board
Prerequisites
Before performing this procedure, Hewlett Packard Enterprise recommends identifying the processor
heatsink assembly components.
Procedure
1. Observe the following alerts.
CAUTION: When handling the heatsink, always hold it along the top and bottom of the fins. Holding
it from the sides can damage the fins.
CAUTION: To avoid damage to the processor or system board, only authorized personnel should
attempt to replace or install the processor in this compute module.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to
the socket or processor, do not touch the contacts.
2. Power down the compute module.
3. Remove the compute module from the frame.
4. Place the compute module on a flat, level work surface.
5. Remove the access panel.
6. Remove the air baffle.
7. Remove the processor heatsink assembly from the failed system board:
a. Loosen the heatsink nuts in the order specified by the label on the heatsink (4 - 3 - 2 - 1).
Removal and replacement procedures 61
To Next Page
Loading...
