HPE Synergy 660 Gen10

• HPE Smart Array SR controllers
• HPE Smart Array MR controllers
A single 96W battery can support up to 24 devices.
After the battery is installed, it might take up to two hours to charge. Controller features requiring backup
power are not re-enabled until the battery is capable of supporting the backup power.
This server supports the 96W HPE Smart Storage Battery with the 260mm cable.
HPE Smart Storage Hybrid Capacitor
The HPE Smart Storage Hybrid Capacitor supports the following devices:
• HPE Smart Array SR controllers
• HPE Smart Array MR controllers
The capacitor pack can support up to three devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 260mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum
firmware requirements to support the capacitor pack.
IMPORTANT: If the system BIOS or controller firmware is older than the minimum recommended
firmware versions, the capacitor pack will only support one device.
The capacitor pack is fully charged after the system boots.
Minimum firmware versions
Product Minimum firmware version
HPE Synergy 660 Gen10 Compute Module system
ROM
2.00
HPE Smart Array SR controllers 1.90
HPE Smart Array MR controllers 24.23.0-0041
Removing and replacing the energy pack
Procedure
1. Power down the compute module .
2. Remove the compute module.
3. Remove the access panel.
4. Place the compute module on a flat, level work surface.
5. Unplug the energy pack cable from the system board.
6. Remove all DIMM baffles, and disconnect the energy pack from the system board.
7. Remove the energy pack.
Removal and replacement procedures 51