hpmont HD3L Series - Function Introduction

Shenzhen Hpmont Technology Co., Ltd. Chapter 6 Function Introduction
HD3L Series Controller User Manual ―41―
Chapter 6 Function Introduction
This chapter will provide user with detail function introduction of each group.
Display Parameters:
d00: Status Display Parameters, on pages 42 - 43.
d01: Drive Status Parameters, on pages 43 - 44.
d02: Analogue Status Display Parameters, on pages 44 - 45.
d03: Running Status Parameters, on pages 45 - 46.
General Parameters:
F00: Basic Parameters, on pages 46 - 47.
F01: Protection of Parameters, on pages 47 - 48.
F02: Start & Stop Parameters, on pages 48 - 49.
F03: Acc / Dec Parameters, on pages 49 - 50.
F04: Analogue Curve Parameters, on pages 50 - 51.
F05: Speed Parameters, on pages 51 - 53.
F06: Weighing Compensation Parameters, on pages 53 - 54.
F07: Asyn. Motor Parameters, on pages 54 - 57.
F08: Motor Vector Control Speed-loop Parameters, on pages 57 - 58.
F12: Digital I/O Terminal Parameters, on pages 58 - 61.
F13: Analogue I/O Terminal Parameters, on pages 61 - 63.
F14: SCI Communication Parameters, on page 63.
F15: Display Control Parameters, on pages 63 - 64.
F16: Function-boost Parameters, on pages 64 - 66.
F17: Fault Protect Parameters, on pages 66 - 68.
F18: PWM Parameters, on page 68.
6