2 Safety information
18
HSD S.p.A. © - h0115k00a.fm291119
2.3 Risks associated with the use of the product
HSD is not responsible for installations performed by persons who are unqualified and/or for
installations that do not comply with the conditions stated in this manual.
The equipment must only be fitted on machinery. The machine manufacturer must conduct a risk
analysis (focusing specifically on the installation type and method) before putting the machine into
service. This kind of analysis must take into account the whole machine life cycle.
2.3.1 Prohibitions and risks associated with improper
handling and/or use
It is absolutely forbidden to bypass, remove, modify or render inoperative any safety devices,
controls or guards protecting individual parts or the product as a whole.
The product must not be used in environments where there is an explosion or fire risk.
The elimination of faults or anomalies in the operation of the product or modifications to the
type of operation or installation must not be carried out by unauthorised personnel.
All guards and safety devices must be maintained efficient and in perfect condition. Warning
and danger signs and symbols must be clearly legible and must never be removed.
When performing troubleshooting operation on the product, take all the necessary precautions
described in the Instruction Manual to prevent damage or injury.
Remember to tighten all screws, nuts and ring nuts of each mechanical component that has
been adjusted or set-up.
Before running the product, make sure that all the safety devices are installed and in perfect
working order. If this is not the case, under no circumstances must the product be started,
instead inform the works safety manager or the department head.
It is not allowed to violate or avoid the prescriptions contained in this manual.
Any uses other than those intended by the manufacturer are not allowed.
Installations, modifications or adjustments not described in this manual, or not authorised by
the manufacturer, are not allowed.
Maintenance intervention modalities, other than those described in the Instructions, are not
allowed.
It is strictly forbidden to replace parts of the equipment. In case of malfunctions or failures,
don't try to repair but send the product to HSD.
2.4 Residual risks
In nominal conditions, the external surface of the device reaches temperatures of 70-80°C.
Wait for it to cool down before touching it.
To Next Page
Loading...
General