HSD SM 137 D - Analytical Index

Analytical index
HSD S.p.A. © - H5834D0189IX.fm291119
67
Analytical index
C
CANopen, 33, 38
CANopen address setting, 43
CANopen configuration, 38
characteristics of the reducers, 56
clamping (see clamping flange)
clamping flange, 24
configuration following a replacement, 35
connections (see "connector" and "installation")
connections (see installation)
Connector, 24
constructor (see "manufacturer")
control method, 56
customer service, 65
D
dipswitch configuration, 35
dip-switches, 24, 35
disposal, 61
documents supplied with the product, 12
EC declaration of conformity, 13
dynamo (see regenerative effect on bus DC)
E
EC, 25
EC declaration of conformity, 13
EC mark, 25
electric connectors, 32
electrical characteristics, 55
electrical connection, 31
electric connectors, 32
standard to use the electric connectors, 32
electrical connections, 31
E-NETx, 33, 36
E-NETx configuration, 36
environmental characteristics, 29
environmental conditions, 47
F
factory
preparing, 29
factory preparation, 29
fieldbus (see "fieldbus interfaces")
fieldbus interfaces, 33, 57
CANopen, 33
E-NETx, 33
RS-485, 34
firmware revision (see "firmware revision number")
firmware revision number, 25
fixing, 30, 51
G
GDT (see "firmware revision number")
GDT (see "product revision number")
general cleaning, 51
general overview of the servo-motor, 24
general post-installation checks, 47
general product description
SM 137, 23
H
hot surfaces danger signs, 25
I
identification of the product, 14
identification plates
identification plate of the manufacturer and of the
product, 25
safety and information signs, 19, 25
installation
electric connectors, 32
electrical connection, 31
electrical connections, 31
fixing, 30
installation area requisites, 29
mechanical connections, 30
overall dimensions, 30
preliminary checks, 29
preparing the factory services, 29
standard to use the electric connectors, 32
tightening screws, 30
installation and commissioning
CANopen address setting, 43
CANopen configuration, 38
configuration following a replacement, 35
dipswitch configuration, 35
E-NETx configuration, 36
environmental conditions, 47
fieldbus interfaces, 33
general post-installation checks, 47
led diagnostics, 46
regenerative effect on bus DC, 34
RS-485 configuration, 44
running-in, 47