HTC 950 RX - Changing Grinding Tools; Preparations for Dry Grinding

HTC 950 RX Usage
1.0 25
4.6.2 Changing grinding tools
1. Remove the grinding tool by giving it a few light taps with a rubber hammer so
the locking mechanism releases, seeFigure 4-14, page 25. Then draw the
tool up out of the guide slot.
Figure 4-14. Removing grinding tools
2. Slide the grinding tool diagonally, from above, down into the appropriate guide
slot on the tool holder, seeFigure 4-12, page 24. Then push the tool fully
into the guide slot.
3. Lock the grinding tool into the tool holder by giving it a few light taps with a
rubber hammer - see Figure 4-13, page 24.
4.7 Preparations for dry grinding
Warning!
Check that the splash guard is fitted.