HTC 950 RX - Usage (continued); Overload and Radio Control Operation

Usage HTC 950 RX
28 1.0
5. Turn the start key to the right "On".
6. Start the grinding discs rotation by turning the knob to "Start".
7. Set the speed for the grinding discs using the Speed knob.
8. The machine has now started.
4.9.4 Overload
If the machine is using too much power, the Overload indicator on the control panel
goes off. The machine switches off automatically after a while if this is ignored. Reduce
the speed of the grinding discs to see if the Overload indicator goes out. If this does not
help, follow the procedure for troubleshooting.
Tip!
If the machine is heavy to operate, it can be due to the placing of the weights.
Fold the weights up or back, to unload the grinding head, seeFigure 4-6, page
19and Figure 4-7, page 20.
4.10 Manoeuvring via the radio control panel
During radio control, the machine is manoeuvred via the radio control unit, seeFigure
3-4, page 13.
Warning!
Never leave the machine unattended when operating via the radio control unit.
When operating via the radio control unit, the machine is driven forwards with the help
of the motors in the drive motor box. From a work environment perspective, operation
via the radio control unit is recommended.
The radio control unit and the machine are individually paired, which means that only
the intended unit can control a machine. The identification code can be seen on the
machine sign and on the radio control unit.