HTC 950 RX - Usage (continued); Stopping and Changing Radio Frequency

Usage HTC 950 RX
30 1.0
3. Zero the radio control unit by doing the following:
- Turn the knob for speed (SPEED) to "min".
- Set the control for driving forwards/backwards (FWD/RWD) in the middle
position.
- Turn the knob for the rotational speed (GRINDING SPEED) to 0%.
- Move the control for starting and stopping the grinding discs' rotation
(ON/STOP) to STOP.
4. Press the button to start radio communication. The communication error
indication (ComError) on the machine's control panel should then go out.
5. Start the grinding discs rotation by moving in the control "ON/STOP" to ON.
Adjust the rotational speed with the knob "GRINDING SPEED".
6. Start the machine's drive motors by moving the control "FWD/RWD" to FWD.
Adjust the speed with the knob "SPEED".
• Check the wheel's locking, if the machine does not move, see instructions under
Wheel locking, page 17.
4.10.3 Stop the machine - Radio control
1. Turn the knob for speed (SPEED) to "min".
2. Set the control for driving forwards/backwards (FWD/RWD) in the middle
position so the machine stops.
3. Turn the knob for the rotational speed (GRINDING SPEED) to 0%.
4. Move the control for starting and stopping the grinding discs' rotation
(ON/STOP) to STOP.
5. Press in the button "EM-STOP", to switch off the radio control unit.
4.10.4 Changing the radio frequency
If several machines are used in the same workplace, there can be interference with the
radio communication, which means that it is necessary to change the frequency on a
machine. It can also be necessary to change the radio frequency, if other equipment that
is used in the workplace causes interference with the radio communication.
Change the frequency, by doing the following: