HTC 950 RX Maintenance and repairs
1.0 35
5.7 Every month (or 100 hours)
• Tighten anything that may have vibrated loose.
• Remove the grinding cover and check that it is undamaged.
• Check the upper belt and replace if necessary.
• Check the seals on the shafts on which the upper belt runs and replace if
necessary.
• Scrape and vacuum-clean the parts shielded by the grinding cover.
• Test run and listen for any dissonance from the bearings.
• Clean or, if necessary, replace the filter to the electrical cabinet.
• Check the functioning of the radio control unit's ME-STOP button.
• Check the parts that wear on the radio control unit, e.g. the dust cover.
5.8 Repairs
Any repairs that may be required must be carried out by a HTC Service Centre, which
has trained service personnel and uses HTC original parts and accessories. Contact your
retailer if your machine requires servicing. For contact information, see Contact
Information at the start of the manual.
5.9 Spare parts
To ensure rapid delivery of spare parts, always specify the model, the machine's serial
number and the spare part number when ordering. Information on the model and serial
number can be found on the machine's name plate.
Information on spare part numbers can be found in the machine's spare parts list which
is available to read or print out from the accompanying digital media or HTC's website:
www.htc-floorsystems.com
Only original tools and original spare parts from HTC may be used. Otherwise neither
the CE marking nor the warranty will be valid.
To Next Page
Loading...
