HTC 950 RX - Usage (continued); Manoeuvring via Control Panel

HTC 950 RX Usage
1.0 27
4.9 Manoeuvring via the control panel
Tip!
Drive the machine manually in difficult to navigate spaces.
During manual driving, the operator pushes the machine forwards across the floor
surface and manoeuvres it via the control panel, seeFigure 3-3, page 12.
4.9.1 Standby
To activate the machine's functions, turn the start key to the right. When the key is in
this position, the Power green indicator light on the control panel is lit, indicating that
the machine is in standby mode.
4.9.2 Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an emergency.
When the switch is pressed, all electrically-powered equipment on the machine are
turned off.
Note!
Do not use the emergency stop switch to stop the machine other than in
emergencies, as it decreases the lifespan of the machine's electrical
components.
Note!
As long as the emergency stop switch (EM-Stop) is pressed, the machine
cannot be started. Reset by turning the switch 45° so that it pops out again. The
machine can then be restarted.
4.9.3 Start the machine - Manual driving
For a description of the control panel, seeFigure 3-3, page 12.
1. Make sure the emergency stop switch has not been activated.
2. Check that the wheel lock is decoupled from the wheel before operating, see
Figure 4-3, page 18.
3. Insert the cable.
4. Start the dust separator if dry grinding is to be done.