HTC 950 RX Usage
1.0 29
1. Loosen the battery cover on the radio control unit by screwing loose the screws
on the cover.
2. Place two charged AA batteries 1.2 V NiMH, or alternatively two normal,
non-rechargeable 1.5 V AA batteries in the battery space.
Note!
Rechargeable batteries must be fully charged before they are used for the
same time.
Warning!
Never attempt to charge standard, non-rechargeable 1.5 AA batteries.
3. Close the cover and fasten it in place with the screws.
• Check that the wheel lock is secured between the wheel and the drive motor, see
Figure 4-4, page 18.
4.10.1 Standby
To activate the machine's functions, turn the start key to the right "On". When the key is
in this position, the Power green indicator light on the control panel is lit, indicating that
the machine is in standby mode.
4.10.2 Start the Machine - Radio Control
Note!
To save energy, the radio control unit automatically switches off if a button is
not activated within a given time. in which case, the blinking points in the
display are extinguished.
1. Turn the knob "Radio On/Off" on the control panel to the right, to prepare the
machine for manoeuvring via the radio control unit, the indicator "Radio
Enables" on the control panel lights up.
2. Press the button "EM-STOP" and then press the button to start the radio
communication on the radio control unit to activate the radio control. The
buttons can be activated in any order, but after you have pressed the first button
the second must be pressed within 5 seconds. When the radio control is
activated, the two points start blinking alternately with a red light on the control
unit's display.
To Next Page
Loading...
