HTC 950 RX - Usage (continued); Handling Weights

Usage HTC 950 RX
18 1.0
• Decouple the wheels by pulling the locking pin straight out, seeFigure 4-3,
page 18.
Figure 4-3. Decouple the wheels
• Turn the locking pin 90 and release it for the secured position, seeFigure 4-4,
page 18.
Figure 4-4. Turn 90 degrees
In order to couple the wheels to the drive motors, the same steps as above are carried
out.
Tip!
During faultfinding, the wheels can be decoupled from the motors and test
driven without the machine moving.
4.4 Handling weights
The machine is equipped with two weights to make it easy to move the machine's centre
of gravity. Each weight is provided with two locking pins with which the weights can be
lowered and locked in three positions; forward, up (normal position) and backwards.
• Pull each pin out and lock in the extracted position by turning in the direction of
the arrow, seeFigure 4-5, page 19.