HTC 950 RX - Usage (continued); Preparations for Grinding

Usage HTC 950 RX
26 1.0
1. Connect a dust extractor to the machine. For dust extractor models, see under the
Suction System tab in the HTC Product Catalogue.
Note!
The dust extractor's suction hose must be connected to the appropriate
socket on the machine. Adjust the dust extractor to match the grinder's
capacity.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine, see under Fitting grinding tools,
page 24
4. Set the handle to the working position, seeFigure 4-2, page 17.
4.8 Preparations for wet grinding
Warning!
Check that the splash guard is fitted.
1. Always use liquid suction when wet grinding.
Tip!
Never use a dust extractor, as blockages may develop in the dust
extractor's suction hose and filter.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine.
4. Set the handle to the working position, seeFigure 4-2, page 17.
Warning!
Only use cold water with no chemical additives.
5. Connect the water hose to the water connection.
6. Turn the tap on the machine on to start the water supply.
7. Turn in the opposite direction to turn the water off.