NOTICE
There must be no exposed metal part at the joints of wire holes and bare wires on
the AC/DC input terminal block.
l Make a DC power input cable.
a. Use a wire stripper to peel about 7 mm length of insulation coating off one end of
the cable.
NOTICE
Do not cut the metal conductor of the cable when peeling insulation coating.
NOTE
Insert the two cables into the AC/DC input terminal block, with the positive cable (+) in the
leftmost hole and the negative cable (-) in the second hole.
b. Insert the bare wire into a hole on the terminal block. Then the reed is closed to lock
the cable in the hole.
Huawei AR500&AR530&AR550 series Industrial Switch
Routers
Hardware Installation and Maintenance Guide
5 Installing an AR550 Series Industrial Switching Router
Issue 05 (2015-12-01) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
114
To Next Page
Loading...
