Figure 6-19 Removing the shield layer of a twisted-pair cable (unit: mm (in.))
Step 5 Lead the four pairs of twisted-pair wires through the wire holder, as shown in Figure 6-20 and
Figure 6-21. Ensure that the colored wires are in the correct location in the cable.
Figure 6-20 Leading wires through the wire holder
Figure 6-21 Cable locations in a wire holder
White-Green
Green
White-Orange
Orange
Blue
White-Blue
White-Brown
Brown
Step 6 Align the four pairs of cables in the holder, as shown in Figure 6-22. The connections
between the wires and the pins are shown in Figure 6-23 and listed in Table 6-26.
Huawei AR500&AR530&AR550 series Industrial Switch
Routers
Hardware Installation and Maintenance Guide
6 Appendix
Issue 05 (2015-12-01) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
147
To Next Page
Loading...
