Huawei EchoLife HG861 User Manual

Table 3-2 Collecting fault information about the GPON service
Num
ber
Item Collecting Method
1
Running status of
the board
Run the following commands in the global config mode:
l display board frameid/slotid
l display version frameid/slotid
NOTE
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
2
Upstream port
information of the
host
Run the following commands in the GIU mode:
l display port state
l display port statistics
l display port opticstate
l display port traffic
NOTE
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
3
Service virtual port
information of the
host
Run the following command in the global config mode:
display service-port port frameid/slotid/portid
Run the following commands in the GPON configuration
mode:
l display port info
l display port state
l display port ont-regiser-info
NOTE
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
4 ONT information
Record the version information about the ONT and status of
each LED.
Run the following commands in the GPON configuration
mode:
l display ont info
l display ont version
l display ont state
l display gemport
l display ont gemport
l display ont gemport mapping
l display ont capability
l display ont port vlan
NOTE
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
3 Configuration Guide EchoLife HG861 GPON Terminal
3-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-30)

Huawei EchoLife HG861 Specifications

General

Brand	Huawei
Model	EchoLife HG861
Category	Network Hardware
Language	English