Figure 5-19 Installing the heat sink
4. Install the heat sink.
– Intel heat sink
i. Use a T20 Torx screwdriver to tighten the two diagonal screws (marked 1 on
the label) on the heat sink. See (1) in Figure 5-20.
ii. Use a T20 Torx screwdriver to tighten the two diagonal screws (marked 2 in
the label) in the middle of the heat sink. See (2) in Figure 5-20.
Figure 5-20 Installing the heat sink
– Huawei-developed heat sink
i. Use a Phillips screwdriver to tighten the two diagonal screws (marked 1 on the
label) on the heat sink. See (1) in Figure 5-21.
FusionServer Pro CH121 V5 Compute Node
User Guide
5 Optional Part Installation
Issue 06 (2019-08-10) Copyright © Huawei Technologies Co., Ltd. 109
To Next Page
Loading...
