Step 8 Click OK.
Step 9 Observe the indicator status of the NVMe drive. If the green indicator is off and the yellow
indicator blinks at 0.5 Hz, remove the NVMe drive slowly.
For details about the drive indicator status, see NVMe SSD Indicators.
For details about how to manually remove an NVMe drive, see 3.13 Removing a SAS/SATA
Drive.
Step 10 Place the removed component in an ESD bag.
Step 11 Install a drive filler.
NOTE
Perform this operation only when a drive is not installed immediately.
----End
Linux OS
NOTE
Use the Intelligent Computing Compatibility Checker to obtain information about the Linux
operating systems supported.
Step 1 Determine the slot and position of the drive.
Figure 3-31 Positions of drives
Step 2 Check the running status of the drive by observing its indicators.
For details, see NVMe SSD Indicators.
Step 3 Determine whether the drive needs to be removed.
l If yes, go to Step 4.
FusionServer Pro CH121 V5 Compute Node
User Guide
3 Basic Operations
Issue 06 (2019-08-10) Copyright © Huawei Technologies Co., Ltd. 55
To Next Page
Loading...
