Version 2.1 (May 2016) 47
6. In Service type, select the service type for the access rule that you want to enable.
7. In Access direction, select LAN to apply the ACL to the traffic entering the LAN
interface, or select WAN to apply the ACL to the traffic entering the WAN interface.
8. Click the Choose devices parameter to select the device or devices where the ACL will
be applied.
9. In Block for, click Select all to apply the settings to all connected devices to the HA35.
Or click the device that you want to activate the ACL. Click Add device, to select
another device.
10. Click Save.
Picture 6-15 ACL
Picture 6-16 ACL 2
To Next Page
Loading...
