You are advised to remove the outer packaging within 24 hours before installing the device.
Unpacking the Device
Step 1 Use diagonal pliers to cut the packaging tape, and use a utility knife to slice the
tape along the gap on the packing case. Slice the tape with caution to avoid
scratching the device inside.
Step 2 Open the packing case and check the deliverables.
----End
Checking Deliverables
After unpacking the device, check that the deliverables are intact and complete
according to the packing list, and check that the device is free from any obvious
damage. If any item is missing or damaged, contact your vendor.
For details about the quantity of deliverables, see the
packing list
in the packing case.
4.5 Moving the Smart PCS
Precautions
Ensure that the lifting handles are installed to the correct screw holes. Do not
install them to the mounting bracket screw holes on the top. Incorrect installation
may cause device damage or personal injury.
● Four persons or appropriate transportation tools are required to move the
device.
● Place a foam pad or cardboard under the device to protect its enclosure from
damage.
● Use lifting handles to facilitate installation, which are optional and delivered
separately. Ensure that the lifting handles are securely installed. After the
installation is complete, remove the lifting handles and keep them properly.
● Secure the lifting handles (with the steel washers of the lifting handles closely
tted to the device).
● If the stud of a lifting handle is bent, replace the lifting handle in time.
● Slowly and steadily hoist, land, and move the Smart PCS to avoid bumping and
damaging the device enclosure.
LUNA2000-200KTL-H1 Smart Power Control System
User Manual 4 Installation
Issue 08 (2024-01-23) Copyright © Huawei Technologies Co., Ltd. 35
To Next Page
Loading...