Figure 5-16 Connecting FE communications cables (to the SmartACU2000D-D-00,
SmartACU2000D-D-01, or SmartACU2000D-D-03)
Procedure
Step 1 Remove an appropriate length of the insulation layer from the shielded network
cable using a wire stripper.
Step 2 Insert the shielded network cable through the sealing nut, sealing ring, coupling
nut, and plastic housing in sequence.
Figure 5-17 Waterproof RJ45 connector composition
(1) Shielded plug (2) Plastic housing (3) Coupling nut
(4) Sealing ring (5) Sealing nut -
Step 3 Line up the exposed wires of the shielded network cable in sequence and connect
them to the corresponding pins in the plug.
Figure 5-18 Connecting a plug
Step 4 Crimp the plug using a crimping tool.
Step 5 Secure the plastic housing to the plug.
Figure 5-19 Connecting a plastic housing
LUNA2000-200KTL-H1 Smart Power Control System
User Manual 5 Cable Connection
Issue 08 (2024-01-23) Copyright © Huawei Technologies Co., Ltd. 57
To Next Page
Loading...