Huawei Mate 8 - Why Do I Hear Rustle When I Use a Headset for Calls; Why Do I Hear Noises When I Use a Headset for Calls; Why Does My Phone Vibrate When I End a Call; Why Does the Headset Announce the Caller Name When a Call Comes in

Huawei Mate 8 Smartphone Feature FAQs
Huawei Mate 8 Smartphone Feature FAQs
9 Calls and contacts
Issue 01 (2016-01-27)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
99
Please use receiver mode or lower the speaker volume if the two phones are close to each
other. You are advised to make handsfree calls with the two phones away from each other.
9.1.5 Why do I hear rustle when I use a headset for calls?
To ensure that you can tell whether the other party has hung up or the call drops when no one
is speaking, a part of the background noise is reserved. This is to bring you a better call
experience and is not a phone issue.
9.1.6 Why do I hear noises when I use a headset for calls?
Some third-party applications (such as WeChat and Baidu Tieba) quickly invoke the speaker
interface after you set up a call (about 200 ms), so the sounds come from the receiver.
If your phone automatically enters handsfree mode when a call comes in, this is caused by a
third-party application (such as WeChat or Baidu Tieba) not your phone system. Turn on Turn
Off Speaker in WeChat or close unnecessary background applications.
9.1.7 Why does my phone vibrate when I end a call?
If you often drive and can't touch your phone for calls, or simply put down your phone after a
call ends when you are busy, it may be hard to tell whether the call has successfully ended
because the screen is turned off. Therefore, as a new feature on your phone, the vibration is a
signal indicating that the call has successfully ended.
Note:
1. Your phone will only vibrate if the other party hangs up.
2. The vibration does not have a switch and is enabled by default.
9.1.8 Why does the headset announce the caller name when a call
comes in?
Go to Dialer and touch > Settings. Check whether Call broadcast is turned on.
If so, and your phone is connected to a headset, the headset will announce the caller name
(number for unknown callers).
9.1.9 How do I set my phone to display the company and position
information on the incoming call screen?
The company and position information is derived from the contacts information, which you
need to update. The following figure shows an example displaying the company information
on the incoming call screen.