Installation Manual
Quidway S3900 Series Ethernet Switches Chapter 5 Loading Boot ROM and Host Software
Huawei Technologies Proprietary
5-5
Note:
The steps that you should take to load Boot ROM program and host software are the
same, except that during Boot ROM program loading you need to press <Ctrl +U> after
accessing the Boot ROM menu and will view different prompt information. Boot ROM
loading procedures are described below for example.
5.3.1 Boot Menu
Starting......
******************************************************************
* *
* Quidway S3924-SI BOOTROM, Version 221 *
* *
******************************************************************
Copyright(C) 2003-2004 2005, Hangzhouby Huawei-3com Technology. Co., Ltd.
All rights reserved.
Creation date : Aug 4 20042005, 141:4728:2247
CPU type : BCM4704
CPU Clock Speed : 200MHz
BUS Clock Speed : 33MHz
Memory Size : 64MB
Mac Address : 0x00e0fc003900
Press Ctrl-B to enter Boot Menu... 2
Press <Ctrl+B> as prompted. The system displays:
Password :
Note:
To access the Boot Menu, press <Ctrl+B> within two seconds after the information
“Press Ctrl-B to enter Boot Menu...” appears; otherwise the system starts to
decompress the program. At this time if you want to access the Boot Menu, you need to
restart the switch.
Input the correct Boot ROM password (no password is set by default). The system
enters the following Boot Menu:
BOOT MENU
To Next Page
Loading...
Need help?
General